The clutch on the walking tractor and the three-wheeled agricultural vehicle is generally a two-piece, often-friction type, which is easy to disassemble and inconvenient to install. Now we introduce a small experience of installing clutches using three old intake valve ducts of type 485 diesel engines. (1) Place the clutch transmission pulley horizontally and place three sets of springs, washers, and dust seals on the outside of the three valve guides, and then place them in the adjusting screw holes in the clutch drive pulley. Then place the six springs in the corresponding positions. The pulley on the spring seat. (2) Insert the three adjusting screws into the inner hole of the valve guide, then install the friction plate and medium pressure plate, and cover the drive pulley cover. At this time, pay attention to the spline holes of the two friction plates. (3) Screw the three M835 bolts evenly into the screw holes and slowly retract the drive cover. At this point the three groups of springs, washers and dust seals are guided under the guidance of the three valve guides and are slowly inserted into the adjustment screw and pushed out from the other side of the clutch transmission pulley. After the three original M814 bolts are screwed on, all three are replaced. On the original bolt. (4) Pull out the three valve guides from the adjustment screw hole on the side of the clutch belt, and then attach the release lever, the coupling pin, the washer and the cotter pin, and screw in the three nuts on the adjustment screw to complete the assembly.
Cherry Tomato,Red Color Tomato,Fresh Cherry Tomato
Chuntian Agricultural Products Co., Ltd. , http://www.km-foods.com